Fenix LR80R

Product description

The new ultra-powerful rechargeable flashlight Fenix LR80R delivers extreme luminous flux of up to 18,000 lumens (ANSI) and a range of up to 1,130 meters. It achieves this performance thanks to six high-end Luminus SST-70 LEDs with a lifetime of 50,000 hours of illumination, which are powered by an internal high-current Li-ion battery with a capacity of 86.4 Wh. The battery is recharged directly in the flashlight via a modern USB-C connector with support for fast charging protocols. With the included 45W USB power supply, it charges in just four hours. The luminaire offers two push-button controls that can be used to separately control high and low light modes, including two hidden flash modes SOS and strobe.

Due to the huge light output, the lamp is equipped with a proximity sensor in the reflector, which automatically reduces the output to 50 lumens when the lamp gets closer to an object than about 6-8 centimeters (prevents damage to the object by strong light and glare from reflected light).

The flashlight is equipped with five indicator LEDs that show the battery charge status. In addition, the flashlight can also be used as an emergency power bank to charge other USB devices. The lamp has a removable handle in the basic package, to which a hanging eye and a tripod thread can be attached. The lamp can be carried in the hand or comfortably slung over the shoulder with the strap. It can also be mounted on a tripod and used as stationary lighting. This searchlight is particularly suitable for rescue and reconnaissance operations. It is also perfect for guarding large objects or for all lighting enthusiasts. It will please both professionals and the most demanding users.

All luminaire parameters (luminous flux, battery life, waterproofness, range, and impact resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

Parameters of the luminaire Fenix LR80R

• The light source is six modern LED Luminus SST-70 with a lifetime of 50000 hours.
• A total of 10 light modes in two groups:
• • High modes: 18000 lumens (2 hours) -> 12000 lumens (2.25 hours) -> 6000 lumens (2.8 hours) -> 3000 lumens (5.1 hours).
  • Low modes: 1000 lumens (15.7 hours) -> 450 lumens (39 hours) -> 150 lumens (92 hours) -> 50 lumens (300 hours) -> Stroboscope (6000 lumens) -> SOS (150 lumens).
• It uses a high-current Li-ion battery built into the body with a capacity of 86.4 Wh (12000 mAh / 7.2 V).
• It takes approximately 4 hours to charge a fully discharged battery with the included 45W USB-C power supply.
• USB output for charging external USB devices such as mobile phones, GPS navigation and other portable electronics.
• The six-part smooth parabolic reflector produces a light cone with an extreme range of up to 1130 meters (318,000 cd).
• The lamp has a memory and will always switch on in the last set mode within the mode group (not valid for flash modes).
• Dimensions 25,9 cm (length) x 5,4 cm (body diameter) x 10,8 cm (reflector diameter).
• Weight 1636 grams (including battery).
• Status LEDs at the control buttons to indicate the battery charge status.
• Made of A6061-T6 aerospace hardened aluminium.
• Durable hard scratch resistant surface - Type III hard anodized.
• Shock-resistant to falls from a height of 1 meter.
• Waterproof and dustproof to IP68 standard (tested underwater at a depth of 2 meters for 30 minutes).
• Tempered ultra clear glass lens with anti-reflective surface.
• Elbow threads with increased wear resistance.
• Able to stand on its own on a flat spot and serve as a candle.
• Sturdy metal handle for comfortable grip (removable).
• The handle can be threaded to screw onto a tripod or to attach a strap.
• Includes internal battery, 45W USB-C mains adapter, USB-C charging cable, shoulder strap adapter and tripod thread, shoulder strap and spare o-ring.

Use

There may be an insulating cap on the battery from the factory. Remove it before first use.

Light control works in the form of two power groups. The right button controls the high power modes and the left button controls the low power modes and hidden flash modes.

Holding the left or right button for 0.5 seconds will switch the luminaire to the last set power mode within the selected mode group (left button = low modes, right button = high modes). Pressing the left button then cycles through the 50-150-450-1000 lumen modes and pressing the right button cycles through the 3000-6000-12000 and 18000 lumen modes.

Holding down the right button for 1.2 seconds will always activate the highest mode of 18000 lumens (even from the off state). Holding the left button for 1.2 seconds will switch the luminaire to strobe mode, then pressing the button again will switch to SOS. The luminaire is switched off by holding down any button for 0.5 seconds as when switched on.

The control buttons can be locked to prevent them from switching on spontaneously, e.g. when transporting in luggage - in the off state, press and hold both buttons for at least 3 seconds, then the lamp will flash to indicate locking. To unlock, both buttons must be held down again for three seconds. Unintentional switching on can also be prevented by loosening the lamp body, thus breaking the electrical contact between the lamp head and the battery.

Charging - Unclip the rubber cap of the charging connector and plug the cable into the USB-C connector in the flashlight, plug the other end into the USB-C connector on the included charging adapter. The indicator LEDs on the flashlight flash from left to right during charging to show the charging status. When charging is complete, all five indicator LEDs remain permanently lit. When charging is complete, seal the connector thoroughly with the rubber cap. During charging, the light can only be used in the lowest mode with a power of 50 lumens.

Charging external USB-C devices (power bank function) - flip off the rubber cap of the USB connector and connect the device you want to charge with a suitable USB cable (only USB-C devices can be charged with the included cable). To activate the powerbank function, press one of the control buttons briefly. Once charging has started, the indicator LEDs will flash from right to left to indicate the battery status. When you're done charging, be sure to properly seal the USB-C connector with the rubber cap. When using the powerbank function, the lamp can be lit in all modes.

Indication of battery charge status - after briefly pressing any button, the indicator LEDs light up for 3 seconds to show the battery charge status (the lamp must be switched off). Five lit LEDs mean the battery is 80-100% charged, four lit 60-80%, three lit 40-60%, two lit 20-40% and one lit LED means the battery is less than 20% charged.

Intelligent overheating protection - when the temperature exceeds 60 °C, the luminaire automatically reduces power in small steps to prevent overheating. Once cooled, it can be switched back to the highest power modes.

The proximity sensor in the reflector will automatically reduce the output to 50 lumens when the luminaire gets closer to an object than approx. 6-8 centimetres (prevents damage to the object by strong light and glare from reflected light).

Notice

• Do not disassemble the sealed parts of the luminaire yourself, this will violate the warranty.
• The battery does not have a memory effect, it can be recharged at any time even after each short use.
• If the protective rubber rings appear damaged after prolonged use, replace them. The rings also need to be lubricated to prevent erosion of the rubber. By following these rules, the luminaire will be properly protected against water.
• If the lamp is flickering, not switching to higher power modes, or not lighting up, it may be due to one of the following reasons:
  • The battery is dead, charge it.
  • The lamp body is loose, tighten it.

Warranty

Five-year warranty on the lamp, two-year warranty on the battery and charger.