Fenix WF05E

Product description

Professional luminaire Fenix WF05E with ATEX/IEC certification for use in explosive atmospheres. The flashlight is powered by two AAA batteries and provides a luminous flux of up to 85 lumens. The lamp body is made of aluminium alloy for high durability and impact resistance and the clasp is made of anti-static plastic. The luminaire is designed especially for firefighters, rescue workers, use in chemical, petroleum, textile and metallurgical plants and other areas where conventional lights cannot be used. It is shaped like a pen and can thus be carried in a breast pocket, for example. The luminaire is not intended for use in mines.

Certificates:

• Applicable in explosive gas zones 1-2 and explosive dust zones 21-22
• Full text of the certificate:
  • IECEx: Ex ib IIC T4 Gb, Ex ib IIIC T130°C Db IP66/IP68
  • ATEX: II 2G Ex ib IIC T4 Gb, II 2D Ex ib IIIC T130°C Db IP66/IP68
  • CSA: Ex ib IIC T4 Gb IP66/IP68; Class I, Zone 1, AEx ib IIC T4 Gb
    Ex ib IIIC T130°C Db IP66/IP68, Zone 21, AEx ib IIIC T130°C Db IP66/IP68

Parametere svluminaires for hazardous areas Fenix WF05E:

• A powerful Cree XP-G2 LED with a lifetime of 50000 hours of light is used.

• Three power mode: 85 lumens (11.5 hours) -> 30 lumens (35 hours) -> 10 lumens (80 hours).

• Uses two micro button (AAA) batteries. The manufacturer strongly recommends using only the following battery types that have been certified for use in the flashlight: Energizer E92, Duracell MN2400 and Panasonic LR03XWA

• Protection against accidental insertion of the battery in reverse (reverse polarity).

• Made of aerospace hardened aluminium, durable surface - Type III hard anodized.

• Surface grooving for better grip.

• Waterproof and dustproof to IP68 standard.

• Smooth aluminium reflector for a perfect light cone with a range of up to 54 metres (724 cd).

• Dimensions 13,45 cm (length) x 1,9 cm (head diameter) x 1,49 cm (body diameter).

• Weight 38 grams (without batteries).

• Included are two Energizer E92 micro alkaline batteries that are approved for use in the flashlight, a spare o-ring and a lanyard.

Usedusage:

To switch on the luminaire, turn the reflector clockwise (tighten the head), the luminaire will always switch on in medium power mode. Turning in the opposite direction turns the torch off again (head clearance). To change the brightness intensity, quickly switch the lamp off and on again from the on state. This switches the luminaire to the next output power level.

Warning:

• Perform all servicing and battery replacement outside explosive atmospheres!

• Never mix batteries from different manufacturers, of different ages or with different discharge levels.

• For long-term storage, we recommend removing the batteries from the luminaire to avoid possible leakage and damage to the luminaire.

• If the protective rubber rings appear damaged after prolonged use, replace them.

• If the lamp flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons:

  • The batteries are almost dead - replace them.

  • The contacts inside the lamp are clogged - clean them with a cotton swab dipped in alcohol.

Warranty

Warranty five years.