Fenix WF11E

Product description

Professional luminaire Fenix WF11E with ATEX/IEC certification for use in explosive atmospheres. The lamp is powered by three AA batteries and provides a luminous flux of up to 200 lumens. The body of the luminaire is made of anti-static plastic (polycarbonate RTP399 x 133887) with high durability and impact resistance. In addition, the lamp is equipped with a fixed clamp with integrated magnet and magnetic end so that it can be attached to anything iron. The luminaire is designed especially for firefighters and rescue workers, it is also suitable as a working luminaire for industrial plants such as chemical plants, refineries, textile mills, paper mills and other plants with an increased risk of explosive gases and dust.

Certificates:

• Applicable in zones 0-2 of explosive gases and in zones 20-22 of explosive dust.

• Full text of the certificates:
  - IECEx: Ex ia IIC T4 Ga / Ex ia IIIC T130°C Da IP66 / IP67
  - ATEX: II 1G Ex ia IIC T4 Ga / II 1D Ex ia IIIC T130 °C Da IP66 / IP67

• It also meets CSA and PCEC certifications.

Parametere ATEX svFenix WF11E:

• A powerful Cree XP-G2 LED with a warmer shade of light with a lifetime of 50000 hours is used.

• Three power modes: 200 lumens (10 hours) -> 100 lumens (29.5 hours) -> 30 lumens (70 hours).

• Uses three AA batteries. Fenix strongly recommends using only battery types that have been certified by the manufacturer: the ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815

• Protection against accidental insertion of batteries in reverse (reverse polarity).

• Made of strong anti-static plastic (polycarbonate RTP399 X 133887).

• Surface grooving for better grip.

• Fixed clasp with integrated magnet.

• Magnetic end cap.

• Dustproof and waterproof to IP67 standard to a depth of 1 metre under water.

• Smooth aluminium reflector for a perfect light cone with a range of over 185 metres (8512 cd).

• Dimensions 16,75 cm (length) x 4,9 cm (head diameter) x 2,4 cm (body width).

• Weight 160 grams (without batteries).

• Included are three Energizer alkaline pencil batteries that are approved for use in the flashlight, a spare o-ring, a lanyard and an EU valid certificate.

Usedusage:

The torch is switched on and off by holding the button on the side for 0.5 seconds. The light modes can be changed by short button presses in the sequence low-medium-high.

To replace the batteries, unscrew the lamp head and remove the battery holder. When replacing batteries, observe the correct polarity marked on the holder. Replace the bracket and screw the lamp head back on.

Notice

• Perform all servicing and battery replacement outside explosive atmospheres!

• In explosive environments, use only batteries that have been certified by the manufacturer: the ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815

• Never mix batteries from different manufacturers, of different ages or with different discharge levels.

• For long-term storage, we recommend removing the batteries from the luminaire to avoid possible leakage and damage to the luminaire.

• If the protective rubber rings appear damaged after prolonged use, replace them.

• If the lamp flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons:

  • The batteries are almost dead - replace them.

  • The contacts inside the lamp are clogged - clean them with a cotton swab dipped in alcohol.

  • The lamp body is loose, tighten it.

Warranty

Warranty five years.