Atsko Silicone Water Guard 350 ml
Product description
Impregnation Atsko Silicone Water Guard 350 ml is a highly effective preparation for waterproofing of fabrics and leather based on silicone polymers. During drying, they are cross-linked. Thanks to its patented composition, the product is unique in that it does not impair the breathability of membrane fabrics (Gore-Tex ®, Sympatex ®, ...). Compared to competing products, it has up to 30% higher durability and treatment efficiency.
Features:
- a single spray is enough to ensure a perfect effect. Repeated injection is not recommended
- is tested for all fabrics made of natural and synthetic fibres: nylon, polyester, composite materials, wool, etc.
- also suitable for suede and sanded leather (nubuck)
- does not damage the breathability of sandwich structures with Gore-Tex® and other membranes
- improves breathability of clothing and footwear
- the water-repellent film formed is completely odourless after drying
- only minimally changes the colour rendering of natural materials (worth a try)
- the treated surface is resistant to salt stains and mapping
- restores and replaces the factory silicone waterproofing of leather boots
- 10g of CO2 is used as the driving gas of the atomizer (the product does not leave a carbon footprint)
Manual:
Shake well before use. First perform a spot test to check for discolouration (judge after drying). The surface to be treated must be clean and dry. When applying, hold the container vertically, nozzle up, 15-20 cm away from the material to be treated and spray slowly until the surface of the material is evenly wet. A single injection is optimal. Use the treated product only after the product has completely dried and matured (polymerised).
Please note: Low temperature, high humidity or reduced air circulation may increase the drying and curing time to 48 hours.
Parameters
Features:
- a single spray is enough to ensure a perfect effect. Repeated injection is not recommended
- is tested for all fabrics made of natural and synthetic fibres: nylon, polyester, composite materials, wool, etc.
- also suitable for suede and sanded leather (nubuck)
- does not damage the breathability of sandwich structures with Gore-Tex® and other membranes
- improves breathability of clothing and footwear
- the water-repellent film formed is completely odourless after drying
- only minimally changes the colour rendering of natural materials (worth a try)
- the treated surface is resistant to salt stains and mapping
- restores and replaces the factory silicone waterproofing of leather boots
- 10g of CO2 is used as the driving gas of the atomizer (the product does not leave a carbon footprint)
Manual:
Shake well before use. First perform a spot test to check for discolouration (judge after drying). The surface to be treated must be clean and dry. When applying, hold the container vertically, nozzle up, 15-20 cm away from the material to be treated and spray slowly until the surface of the material is evenly wet. A single injection is optimal. Use the treated product only after the product has completely dried and matured (polymerised).
Please note: Low temperature, high humidity or reduced air circulation may increase the drying and curing time to 48 hours.
Share your opinion with others
Add reply to comment: